![\"Rubber](\"https:\/\/i0.wp.com\/dewals.nl\/wp-content\/uploads\/2014\/09\/IMG_2050.jpg\")
<\/a>Rubber magpulls<\/p><\/div>\n
I searched the internet high and low and found one<\/a> but it didn’t have a proper howto. It only showed the end result. But I now had a general idea on how to make my own magpulls.<\/p>\n my gunbag came with straps so you could wear it as a backpack but I have no intention to do so. These would work for straps. Now I needed a role of tape and I was set to be creative.<\/p>\n the materials needed<\/p><\/div>\n <\/p>\n Needed are: scissors,\u00a0 straps, tape and your magazines. While there isn’t much that could happen I would like to remind you that beyond this point everything is at your own risk and I cannot be held responsible for any damage to you or your magazines.<\/p>\n tape up the end<\/p><\/div>\n Tape up one end of the strap. Wrap the tape around it 2 or 3 times and then rub the tape so it sticks to the strap even better. Both ends taped up<\/p><\/div>\n <\/p>\n Next we take one end of the taped strap and place it on the tape as on the picture below<\/p>\n place the end of your magpull on the tape<\/p><\/div>\n <\/p>\n Place this on the magazine as seen below.<\/p>\n place the tape with the magpull on the magazine<\/p><\/div>\n <\/p>\n Now we’re going to hold the other end as seen below.<\/p>\n hold the other end in place before you tape up the entire magazine<\/p><\/div>\n Carefully wrap the tape around the magazine so that both ends are now taped to the magazine. Wrap the tape 2 or 3 times and then cut it and rub it so it sticks better to your magazine.<\/p>\n<\/a>
\nAfter a few failed attempts I came up with the following and for now it seems to work wonderful.<\/p>\n<\/a>
\nThen hold the taped end on your magazine, make the desired size of your magpull. Mark where the straps starts on the other side of the magazine. I used my finger.
\nPlace this end on the tape and use your scissors to cut off the strap. Make sure it’s the side that’s too much and not the side that goes to the already taped up end. Then wrap the tape round the second end just like you did with the first end.
\nThe result will be like the image below.<\/p>\n<\/a><\/a><\/a><\/a>